Remaining System Installation - Motorola HC05F6 User Manual

2.3

REMAINING SYSTEM INSTALLATION.

HC05F6EM USER'S MANUAL
When you have configured headers P4, P6, P9 and P10, you are through
with F6EM configuration:
• To install the F6EM in an MMDS05 station module, remove the
panel from the station-module top. Fit together EM connectors P2
and P3 (on the bottom of the board) and control-board connectors
P11 and P12. Snap the mounting holes of the EM onto the plastic
standoffs. Connect the target cable, if appropriate. Replace the
panel.
• If your F6EM already is installed in the station module, reconnect
the target cable, (if necessary). Replace the panel.
At this point, you are ready to make remaining cable connections, as
necessary, and restore power. For instructions, consult the MMDS05
operations manual (MMDS05OM/D).
2
MOTOROLA
2-5