Motorola MVME2400 Series Installation And Use Manual page 41

Avoid touching areas of integrated circuitry; static discharge can damage
!
these circuits.
Caution
4. Slide the MVME240x (and PMCspans if used) into the selected
5. Secure the MVME240x (and PMCspans if used) in the chassis with
Note
6. On the chassis backplane, remove the
7. If you intend to use PPCBug interactively, connect the terminal that
8. Replace the chassis or system cover(s), cable peripherals to the
9. The MVME240x's green
http://www.motorola.com/computer/literature
card slot(s). Be sure the module or modules is/are seated properly in
the P1 and P2 connectors on the backplane. Do not damage or bend
connector pins.
the screws provided, making good contact with the transverse
mounting rails to minimize RF emissions.
Some VME backplanes (for example, those used in Motorola
"Modular Chassis" systems) have an auto-jumpering feature for
automatic propagation of the IACK and BG signals. Step
not apply to such backplane designs.
(IACK) and
BUS GRANT
slot occupied by the MVME240x.
is to be used as the PPCBug system console to the
the front panel of the MVME240x.
In normal operation the host CPU controls MVME240x operation
via the VMEbus Universe registers.
panel connectors as appropriate, reconnect the system to the AC or
DC power source, and turn the equipment power on.
confidence tests is run, and the debugger prompt
appears.
INTERRUPT ACKNOWLEDGE
(BG) jumpers from the header for the card
LED indicates activity as a set of
CPU
Hardware Installation
6 does
port on
DEBUG
PPC1-Bug>
1-21
1