Remaining System Installation - Motorola M68EM05D32 User Manual

2.3 REMAINING SYSTEM INSTALLATION

When you have configured headers J1 through J4 and switches S1 and S2, and made sure that
the resident MCU is appropriate, you are through with D32EM configuration:
• To install the D32EM in an MMDS05 station module, remove the panel from the station-
module top. Fit together EM connectors P2 and P3 (on the bottom of the board) and
control-board connectors P11 and P12. Snap the corners of the EM onto the plastic
standoffs. Connect the target cable, if appropriate. Replace the panel.
• If your D32EM already is installed in the station module, reconnect the target cable (if
necessary). Replace the panel.
At this point, you are ready to make remaining cable connections, as necessary, and restore
power. For instructions, consult the MMDS05 operations manual (MMDS05OM/D).
M68EM05D32/D
MMDS05 CONFIGURATION AND OPERATION
2-8 MOTOROLA