Secondary Pmcspan Module - Motorola MVME2300SC Series Installation And Use Manual

Hardware Preparation and Installation
1

Secondary PMCspan Module

!
Caution
!
Warning
!
Caution
1-16
The PMCspan-010 PCI expansion module mounts on top of a PMCspan-
002 PCI expansion module. To install a PMCspan-010 on your
MVME2300SC, refer to
procedure assumes that you have read the user's manual that was furnished
with the PMCspan, and that you have installed the selected PMCs on the
PMCspan according to the instructions given in the PMCspan and PMC
manuals.
1. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VME card cage.
Inserting or removing modules with power applied may result
in damage to module components.
Dangerous voltages, capable of causing death, are present in
this equipment. Use extreme caution when handling, testing,
and adjusting.
2. If the Primary PMC Carrier Module/MVME2300SC assembly is
already installed in the VME chassis, carefully remove the two-
board assembly from the VMEbus card slots and lay it flat, with the
P1 and P2 connectors facing you.
Avoid touching areas of integrated circuitry; static discharge
can damage these circuits.
3. Remove the four short Phillips screws from the standoffs in each
corner of the primary PCI expansion module, PMCspan-002.
4. Attach the four standoffs to the PMCspan-002.
5. Place the PMCspan-010 on top of the PMCspan-002. Align the
mounting holes in each corner to the standoffs, and align PMCspan-
010 connector P3 with PMCspan-002 connector J3.
Figure 1-5 and perform the following steps. This
Computer Group Literature Center Web Site