Setup Gui - Events - Overview - junger V*AP Manual

Setup GUI – EVENTS – Overview
As mentioned previously, V*AP includes a sophisticated event management system.
The event system performs Actions. These actions are build from Events.
Actions may be triggered manually (via the X*AP RM
(triggered by network commands or GPIs) and automatically (triggered by changes of parameters or the
internal status) or as a combination of all three.
The overview shows the building blocks of the action management of the V*AP :
A trigger is subdivided into a trigger type and a trigger source. E.g. a GPI is a trigger type while its number
(the physical input) represents the trigger source. Other trigger types have sources which may be
configured, like X*AP Hotkeys :
Remote Hotkeys
Network
Parameters
The V*AP uses three different event types :
Preset Events
I/O Events
Bypass Events
The V*AP has two different action types – "Event Actions" and "Bypass Actions"
An action runs like a flip-book inside the V*AP. This powerful technology spans from simply recalling a
certain parameter over narrator specific parameter combinations (household name: "Preset") to the
complete reconfiguration of the V*AP including all signal routing, processing parameters and so forth.
It allows you to create your own snap shots where you decide what is part of it and what is not!
But it also enables several fail over scenarios where the V*AP will automatically react to the system
and/or parameter status.
The steps to set up the EVENTS system are as follows :
1. Define
2. Configure
3. Set up events
4. Create actions
You may assign hotkeys of the X*AP remote to become a trigger
source.
Received via the l-s-b EmBER+ protocol.
Device parameters / status information grouped into
system and Interfaces.
System / Interfaces / Routing / Audio Processor /
Voice / Program / Monitor
GPOs / Loudness Measurement
- trigger sources
- triggers by logical combination of pre defined trigger sources
- by selecting presets for function blocks
- what shall happen - which trigger will launch which event?
remote panel Hotkeys), semi-automatically
1
44
V*AP