Table of Contents
Advertisement
V*AP
Important note! The AES relay bypass circuit of the I/Os is deactivated inside the V*AP. It is possible
to activate it if necessary. You must open the cover plate from the V*AP unit and locate the jumper
shown in the schematic below :
You must insert the jumper to activate the AES I/O for power fail operation.
Output Channel Status
Set up GUI – INTERFACES – Analog Mic
The channel status can be either
transparent from the input source
of the V*AP or may be overwritten.
The pull down offers these options :
Setup
Input
Enable Preamp Gain [On / Off]
Preamp Gain (dB)
Pad (dB)
Phantom Power
21
[Mic / Line]
[10 ... 65]
[Off / -10]
[On / Off]
Advertisement
Table of Contents
