System Commands - Pepperl+Fuchs IC-KP-R2-V1 Manual

IC-KP-R2-V1
Commands
Note!
The device makes no distinction between commands entered in upper and lower case. Make
sure that there are no spaces in all parameters that come after the command.
7.3.1

System commands

Version (VE):
Command:
Response:
(Channel 1)
(Channel 2)
(Channel 3)
(Channel 4)
This command transfers the device names and the date of the software versions.
If there is no R/W head connected, the R/W head information is omitted and
6<Ident channel><CHCK><ETX>
is displayed to indicate that the R/W head was unavailable (status = '6').
Change tag (CT):
Command:
Response:
This command tells the read/write head on the relevant channel which tag type to communicate
with. This setting is stored in the non-volatile memory on the unit.
Supported Tag Types
Tag type P+F
designation
High Low
byte byte
'0' '2' IPC02
'0' '3' IPC03
'1' '1' IPC11
'1' '2' IPC12
26
VE <CHCK><ETX>
<Status> P+F IDENT
<Model type>
#<Part no.>
<SW no.>
<SW date> <CHCK> <ETX>
<Status> <Ident channel> <LkName>
#<Part no.>
<SW no.>
<SW date> <CHCK> <ETX>
<Status> <Ident channel> <LkName>
#<Part no.>
<SW no.>
<SW date> <CHCK> <ETX>
<Status> <Ident channel> <LkName>
#<Part no.>
<SW no.>
<SW date> <CHCK> <ETX>
<Status> <Ident channel> <LkName>
#<Part no.>
<SW no.>
<SW date> <CHCK> <ETX>
CT <Ident channel><TagType><CHCK><ETX>
<Status><Ident channel><CHCK><ETX>
Chip type Access
Unique, EM4102 (EM Read only code
microelectronic)
EM4450 (EM Read/write read
microelectronic),
Titan
Q5 (Sokymat)
P+F FRAM Read/write read
Writable
memory
[bytes]
5
116
only code
Read/write 5
8k
only code
Read only Frequency
code length range
[byte]
5 125 kHz
4 125 kHz
- 125 kHz
4 125 kHz