Pepperl+Fuchs IC-KP-R2-V1 Manual page 41

IC-KP-R2-V1
Commands
Example:
RP1UE5.00.00 outputs the number of unsuccessful read attempts until status 5.
Syntax
RP
Write Parameters
Command WP writes configuration parameters to the read/write head.
Command:
Response:
<SystemCode> = U
<ParamTyp> = 2 bytes ASCII
<DataLength> = Length of <Data>, 2 bytes binary
<Data> = Optional additional information
Example:
WP1UE5.00.01.05 sets the number of unsuccessful read attempts to status 5 on 5 attempts.
Syntax
WP
IQH2-...: <SystemCode> = 'Q' ASCII (51
IUH-...:
<SystemCode><ParamTyp>
WP <ChanNo> <SystemCode> <ParamTyp> <DataLength> <Data>
<CHCK> <ETX>
<Status> <ChanNo> <CHCK> <ETX>
for IUH-*
ASCII
<SystemCode><ParamTyp><Length
><Value>
<ParamTyp> = 'K1' ASCII (4B
RP: reads the key (12 characters ASCII from 0 ... F) from the
transponder and the read head
WP: writes the key (12 characters ASCII from 0 ... F) into the
read head
Default key = 'FF FF FF FF FF FF' ASCII
(46 46
h
See handbook of the read / write head
)
h
31 )
h h
46 46 46 46 46 46 46
h h h h h h h h
46 46 46 )
h h h
41