Final Work - Webasto Thermo Top Evo Installation Documentation

Seat Leon

Final Work

WARNING!
Reassemble the disassembled components in reverse order. Check all hoses, clamps and all electrical
connections for firm seating. Insulate all loose wires and tie back.
Only use manufacturer-approved coolant. Spray heater components with anti-corrosion wax
(Tectyl 100K, Order No. 111329).
• Connect the battery.
• Fill and bleed the coolant circuit according to the vehicle manufacturer's specifications.
• Adjust digital timer, teach Telestart transmitter.
• Make settings on A/C control panel according to the "Operating Instructions for End Cus-
tomer".
• Place "Switch off parking heater before refuelling" signboard in the area of the filler neck.
• For initial start-up and function check, see installation instructions.
Ident. No.: 1319064A_EN
1
76
3 2
Status: 14.01.2013
Centrally align exhaust end section 3 in pass
through.
1 Wheel well trim mounted
2 Underride protection installed
Aligning
exhaust
end section
Webasto Thermo & Comfort SE
Postfach 1410
82199 Gilching
Germany
Internet: www.webasto.com
Technical Extranet:
http://dealers.webasto.com
© Webasto Thermo & Comfort SE 30