Preliminary Work; Heater Installation Location - Webasto Thermo Top Evo Installation Documentation

Seat Leon

Preliminary Work

Vehicle
• Open the fuel tank cap.
• Ventilate the fuel tank.
• Close the fuel tank cap again.
• Depressurise the cooling system.
• Disconnect the battery and remove it completely, including the carrier.
• Completely remove the air filter box together with the intake hose of the radiator (TDI only).
• Remove the underride protection.
• Remove the fuel tank underride protection if present.
• Remove the right front wheel.
• Remove the front right wheel well trim.
• Completely remove the horns with the bracket.
• Remove the instrument panel trim on the driver's side.
• Remove the A-pillar trim on the driver's side.
• Remove the footwell trim on the front passenger's side.
• Remove the rear seats.
• Open the right-hand tank-fitting service lid.
• Remove the fuel-tank sending unit in accordance with the manufacturer's specifications.
Heater
• Remove years that do not apply from the type and duplicate label.
• Attach the duplicate label (type label) in the appropriate place inside the engine compartment.
Note:
The installation steps are nearly identical for both the TSI and TDI. Deviations have been documented, apart from
that all images show a 1.6 TDI.
Ident. No.: 1319064A_EN
1
1
Status: 14.01.2013

Heater Installation Location

1 Heater
Installation
location
© Webasto Thermo & Comfort SE 5