Final Work - Webasto Thermo Top Evo Installation Documentation

Kia Rio

Final Work

Reassemble the components in reverse order. Check all hoses, clamps and all electrical connec-
tions for firm seating. Insulate loose wire ends and tie back.
Only use manufacturer-approved coolant. Spray the heater components with anti-corrosion wax
(Tectyl 100K).
• Connect the battery.
• Fill and bleed the coolant circuit according to the vehicle manufacturer's specifications.
• Program MultiControl CAR, teach Telestart transmitter.
• Make settings on A/C control panel according to the 'Operating Instructions'.
• Place the 'Switch off parking heater before refuelling' caution label near the filler neck.
• For initial startup and function check, please see installation instructions.
1
Ident. No.: 1318004J_EN
2
280
100
2
1
Status: 30.03.2016
Copy hole pattern 1 for 60mm dia. hole
and drill.
2 Underride protection
85
Install underride protection 2 . Align ex-
haust end section 1 centrally in hole and
flush with underride protection 2 .
86
© Webasto Thermo & Comfort SE
Cutting out
underride
protection
Aligning
exhaust
end section
Webasto Thermo & Comfort SE
Postfach 1410
82199 Gilching
Germany
Internet: www.webasto.com
Technical Extranet:
http://dealers.webasto.com
33