Preliminary Work; Heater Installation Location - Webasto Thermo Top Evo Installation Documentation

Ford Mondeo

Preliminary Work

Vehicle
• Open the fuel tank cap.
• Ventilate the fuel tank.
• Close the fuel tank cap again.
• Depressurise the cooling system.
• Completely remove the air filter box.
• Disconnect and remove the battery together with the battery carrier.
• Remove the front underride protection (to drain the coolant).
• Remove the engine underride protection.
• Remove the left-hand underbody protection.
• Remove the fuel tank underbody protection on the right and left hand sides.
• Remove the right-hand front wheel.
• Remove the right-hand wheel-well inner panel.
• Lower the exhaust pipe and middle silencer.
• Remove the fuel tank according to the manufacturer's instructions.
• Remove the lower footwell trim on the front passenger's side (only in case of Telestart and/or
Thermo Call).
• Remove the trim strip and air outlet trim over the glove compartment (only in case of Telestart
and/or Thermo Call).
• Remove the glove compartment (only in case of Telestart and/or Thermo Call).
Heater
• Remove years that do not apply from the type and duplicate label.
• Attach the duplicate label (type label) at the appropriate place in the engine compartment.
Ident. No.: 1323975A_EN
1
1
Status: 12.06.2015

Heater Installation Location

1 Heater
© Webasto Thermo & Comfort SE
Installation
location
5