4�3� Editing Display And Operation Settings; 4�3�1� Settings Prompts - Vertiv Liebert GXT5 Series Installer/User Manual

4.3. Editing Display and Operation Settings
You may adjust the display settings and UPS configuration via the LCD� The display and operation settings are
password protected� The default password is 111111 (six ones)�
NOTE: We recommend that you change the password to protect your system and equipment and record the
new password and store it in an accessible location for later retrieval. See
page.
To enter the password:
1� Press the up-arrow button to change the digit, then press the down-arrow button to move to the next digit�
2� Repeat to select each digit, and press Enter to submit the password�
Figure 4-9 Password Prompt
4.3.1. Settings Prompts
While using the operation and display panel, prompts display to alert you to specific conditions or require
confirmation of commands or settings�
Table 4-5 Display Prompts and Meanings
PROMPT
Cannot set this online, please
shut down output
Incorrect password, please input
again
Operation failed, condition is
not met
Password changed OK
Fail to change password, please
try again
The time cannot be earlier than
system time
Turn on failed, condition is not
met
Cannot set this on line, please
unplug REPO
Vertiv | Liebert® GXT5™ | Installer/User Guide
Table 4-5 lists the prompts and their meaning�
MEANING
Appears when changing important output settings (output voltage, output frequency, output phase No�)�
Appears when the Settings password is input incorrectly�
Appears when attempting to execute a operation for which the required conditions are not met�
Appears upon successful change of the Settings password�
Appears when attempting to change the Settings password but the new and confirmation passwords do not match�
Appears when attempting to set the time of 'Turn on delay' or 'Turn off delay' earlier than the current system time�
Appears when proper conditions are not met for UPS power-on� Applies when using the power button or when
execute the command of 'Turn on/Turn off/to Bypass' on the LCD panel 'Control' page)�
Appears when attempting to change the output phase number while the output is connected�
Changing the Password on the next
47