Figure 5-1: Pid Gateway Module - ADT FOCUS 200 PLUS Installation And Setup Manual

FOCUS 200 PLUS Installation and Setup Guide
GATEWAY
MICROPROCESSOR
RS-485 BUS
ADDRESS JUMPERS
JUMPER E10
PID Gateway Applications
The PID Gateway is limited to applications involving the following items that cannot be used with the
SIM Gateway:
•
471898(7187-028) Quad Powered Sounder PID Module.
•
7187-039 Waterflow Retard Module.
•
471998(7187-112) Remote Keyswitch (requires 411997(7187-097) Switch Interface Module).
•
471999(7187-113) Janitor Keyswitch (requires 471997(7187-097) Switch Interface Module).
•
471921(7187-061) Daytime Annunciator.
Additionally, the following sensors must be connected to the PID gateway:
•
Lacing and foil.
•
4058 Type Glassbreak Detectors.
5-4
RS-485 BUS LEDs
TXD (YEL) RXD (RED)
RS-485
DS1 DS2
TXD RXD
E2
E3
E4
U6
E5
E6
E7
E8
E9
E 10
(BLU) 4 TRUNK 1A
(YEL) 3
(RED) 2
(BLK) 1
TB2
TERMINAL STRIP
TB2 FOR TRUNK 1A
0 1
E2
UNIT NO.
E3
E4
E5
E6
COMMUNICATION
E7
GROUP NO. 3
E8
E9
JUMPER IN
JUMPER CONDITIONING SHOWN FOR COMMUNICATION GROUP 3
IN COMBINATION WITH UNIT NUMBERS 0 THROUGH 7.
NOTES:
1. RS-485 BUS LEDs:
(A) TXD (YEL) FLASHES WHEN GATEWAY IS TRANSMITTING
(B) RXD (RED) FLASHES WHEN GATEWAY IS RECEIVING.
2. A 248116 TAMPER KIT MAY BE ORDERED SEPARATELY;
CONSISTS OF TAMPER SWITCH PLUS MOUNTING HARDWARE.
3. REMOVE JUMPERS E10 AND E11 UNLESS GATEWAY IS BEING
POWERED BY A SEPARATE POWER SUPPLY THAT IS RATED
AT MORE THAN 0.5A (SEE PHYSICAL DESCRIPTION).

Figure 5-1: PID Gateway Module

TERMINAL STRIP TB1
CONNECTIONS TO
RS-485 BUS
TB1
(BLK) 1 GND
(RED) 2 + 12V E1
(YEL) 3 COM
(BLU) 4 COM +
TRUNK 1B
TA
FOR TAMPER
(IF USED)
SEE NOTE 2
2 3 4 5 6
JUMPER OUT
JUMPER E1
(REMOVE JUMPER TO
DISCONNECT RS-485
TERMINATING RESISTOR)
JUMPER E11
E 11
1 (BLK)
2 (RED)
3 (YEL)
4 (BLU)
TB3
TERMINAL STRIP
TB3 FOR TRUNK 1B
7
UNIT NO.