ADT FOCUS 200 PLUS Installation And Setup Manual page 153

< ? FRONT DOOR 20
IS _____ Continue >
OPTION 2
< Previous Change >
< ? FRONT DOOR 20
IS _____ Continue >
OPTION 3
< Previous Change >
< ? RF Point?
Continue >
No >
Yes >
< ? RF information
< Type RF Continue >
< Loop 1
< Previous
< ? Enter User #
Continue >
BR User # _ _ _ 0
< Previous Enter >
This is Option 2 Screen.
The function of Option 2 changes depending on the type of point
being used.
For Input Point Types 1 to 8, 10, 11, 13, 35, 60, 64 = N/C
Contact:
Select whether a normally closed contact is used. If so, an open in
the loop wiring will be ignored during the Day Set, but will initiate
an alarm during the Nite Set.
For Output Point Type 34 = Output Link:
Select whether this output will follow the status of a designated
output point.
For Output Point Types 27, 38 = Common BA:
Select whether the output will be turned on by an alarm in only
one BA group or by an alarm in any one of a series of BA groups.
For All BA RF transmitters option 2 must be enabled (IS).
Select Change to toggle the option.
Select Continue to save the selection and move to the next option
screen.
This is Option 3 Screen.
The function of Option 3 changes depending on the type of point
being used.
For Input Point Types 1 to 9, 13 = Self-Test:
Select whether the device will perform a self-test. This is for
devices with a built-in SIM that have self-test capability.
For Input Point Types 10, 11 = Latch Contact:
Select whether a momentary contact is used on the loop to initiate
an alarm.
For Input Point Types 60, 64 =SIM:
Select whether the pushbutton will be connected to a SIM
Gateway.
Select Change to toggle the option.
Select Continue to save the selection and move to the next screen.
This is the RF Programming Screen.
Select Continue if you do not desire to change the RF information
for this point.
Select No if the point is not an RF point.
Select Yes if the point is RF or if there is any information
concerning this point that needs to be changed. This will move you
to the RF Information Screen.
RF Information Screen is displayed.
Select Type to scroll through the choices (RF, UR, BR) for the
type of RF point.
Select Loop to scroll through the loops (1-4) for this point
Select Continue to save the info and move to the next screen.
BR User # Screen is displayed.
If the type selected was BR, this screen is displayed.
Enter the User # associated with this RF transmitter.
Select Enter to save the user #. The Enter key changes to Delete.
Select Delete to erase the user # displayed.
Select Continue to move to the Hard ID Screen.
Section 14 – Programming
14-5