ADT FOCUS 200 PLUS Installation And Setup Manual page 3

Differences Between the FOCUS 200B and the FOCUS 200 PLUS Systems
Item
Built-in Hardwired
Points
Built-in Output
Triggers
Dialer
ADT AC
Communicator
Module
DES Encryption
Service Telco Jack
Transformer
FOCUS 200B
None
None
•
Both a main and secondary dialer on a
communicator card
•
Supports ADT SIA (FSK) format only
On the communicator card
Supported on the communicator card
Mounted external of the cabinet
Supports 16.5VAC transformers only
•
16.5VAC (50VA) transformer provides
1A max output current
•
16.5VAC (82VA) transformer provides
2A max output current
FOCUS 200 PLUS
8 Hardwired Points
•
EOLR supervision using a 2k resistor
•
Support of normally-open or normally-
closed sensors
•
Up to 16 2-wire smoke detectors each
on points 1 and 2 (32 total)
•
Points 3 and 4 may be set for a style
"D" configuration
•
Point 8 may be configured as a bell
box tamper
8 Output Triggers
•
Each output may be programmed to
any of the output point types
•
May be used to trigger Long Range
Radio
•
May be used to trigger a relay
•
Main dialer is built-in
•
Secondary dialer (472402A) is an add-
on module
•
Supports ADT SIA and ADEMCO
Contact ID formats
Add-on module (472491)
Not supported in this version
Located on the main PC board (Control
Unit)
Supports 18VAC and 16.5VAC
transformers
•
18VAC (50VA) transformer provides
1.5A max output current
•
18VAC (72VA) transformer provides
2.3A max output current
•
16.5VAC (50VA) transformer provides
1A max output current
•
16.5VAC (82VA) transformer provides
1.8A max output current
Note: Use 18VAC transformer for all
new installations. Use 16.5VAC
transformer for retrofit only.
iii