Programming The System Communication Options - ADT FOCUS 200 PLUS Installation And Setup Manual

< ? Grp0 Ut0 Keypad
< BA-
< Previous
< Quit
< ? Grp4 Ut0 Cardrdr
< BA-
< Previous
< Quit

Programming the System Communication Options

Enter the program mode by entering the Service Code at the operating panel.
< ?
< Lesson
< See alarms
< Quit
< ?
< Sys info
< Name pnt/gps
< Previous
< ?
< ST P#
< DTM/Lst
< Quit
< ?
< Pri Phone Num
< Pls/Lst
< Quit
This screen shows which BA Groups will be automatically opened
(turned off) when a valid ID Code is entered at the operating panel
indicated.
Change >
Select Change to edit the selections. Enter the number of each BA
Next >
Group that will turn off. Entering the number again will erase the
selection.
Select Next to move to the operating panel at the next address on
the RS-485 bus.
Continue until all operating panels have been programmed.
Selecting Next at the last operating panel will bring you to this
screen.
Lg (N) >
This screen is same as the one for the operating panels, except this
Change >
is for BA Groups linked to card/key readers.
Next >
Select Change to edit the selections.
Select Next to move to the card/key reader at the next address on
the RS-485 bus.
Selecting Lg will toggle between Yes (Y) and No (N) to log
successful attempts, unsuccessful attempts, openings, and closings
at this card/key reader in the history log.
Selecting Next at the screen showing the last card/key reader will
bring you to the Point Data Info Screen.
Select Quit to return to Action Menu #4.
Action Menu #1 is displayed.
Enter choice:
Select More three times.
Turn on >
Reset >
More >
Action Menu #4 is displayed.
Enter choice:
Select Load to continue.
ID codes >
Load >
First >
The Communication Screen is displayed.
SS-GG-IIII >
Select More to program the CCC phone number.
Remote DLL >
Local DLL >
More >
The CCC Options Screen is displayed.
Pri Num/Hex Edi
Select the Pls/Lst key to scroll through the dialing methods. The
choices are:
CID >
Hex Data >
Select the CID key to toggle between Contact ID (CID) and
Security Industry Association (SIA) formats.
Select Pri Phone Num to program the primary CCC phone
number.
Select Hex Data to program the hex data information.
Pls/Lst = Pulse dialing and loop start
Dtm/Lst = TouchTone dialing and loop start
Pls/Gndst = Pulse and ground start
Dtm/Gndst = TouchTone and ground start
Section 14 – Programming
14-7