Action Menus - ADT FOCUS 200 PLUS Installation And Setup Manual

FOCUS 200 PLUS Installation and Setup Guide
Activating the Operating Panel
If the system is in a normal, non-alarm state, pressing any digit key activates the operating panel to
display the off/on status of the burglar alarm protective group(s).
Entering a valid 6-digit ID code causes the operating panel to activate, bringing up the Action Menus.
Then selections and entries can be made as required.
Screen Duration of the Operating Panel
If, while you are in the process of performing an operation, a predetermined period elapses without
making a selection, the display will revert to the screen showing the status of the system, provided that
all parts of the system are normal.
The various screen durations are as follows:
Screen
Normal no-alarm
Action Menu #1 screen
After a selection at Action Menu #1
After an ADT Service Code is entered
Test In Progress
Operating Panel Sounder
The operating panel sounder will annunciate to signal specific conditions as follows:
Condition
Each depression of a selector button or digit key
Acceptance of a valid code or a function
Fire Alarm
BA Alarm
Trouble or Supervisory
Entry Delay−reminder to turn off
Exit Delay−reminder to exit
End of Exit Delay
Auto On Reminder−reminder to close (beeps start
15 or 30 minutes before closing, as programmed)
Auto On Warning−warning to either exit or extend
closing time (beeps start either 5 or 15 minutes
after closing, as programmed)
Audible-on-Schedule Enable (if optioned)
Test Mode in Progress
During Audible Walk Test
When a sensor is activated during the walk test

Action Menus

Operation of the system is based on selecting a course of action from menu items that appear on a
series of screens known as Action Menus. Provided the associated BA protection is off, entering a valid
ID code causes the first of four Action Menus to be displayed.
The Action Menus are the starting point for performing all operations other than turning the system
off. Selection of a menu item results in the display of another screen. Continue making selections until
the appropriate screen is displayed and the desired course of action has been completed.
The four Action Menus and the explanation for each of the keys at each menu follows.
19-2
Duration
7 seconds
Approximately 10 seconds
60 seconds
4 minutes
Continuously until reset
Sounder Pattern
A short beep
A longer beep
Pulsating 1-second-on, 1-second-off with a 5-
second pause every 10 seconds
Steady tone
Intermittent pulsating (2 beeps, 1 second off)
Steady tone
1-second beep every minute
4-second beep
1-second beep every minute
Steady tone
1-second beep every minute
1-second beep every minute
Pulsating 1-second-on, 1-second-off
Steady tone