To Change Your Master Code; Quick Arming; Phone Module - ADT SAFEWATCH PRO User Manual

Duress Code (Con'd)
CAUTION:
Use of a Duress code may
inadvertently cause a
Duress signal to be sent to
the Customer Monitoring
Center.
Extreme caution must be
used in using this feature to
prevent false alarms.
To Change Your Master
Code

"Quick Arming"

#
Using the Key
==
Smartphone
PHONE ACCESS CODE
(if applicable)
SECURITY CODES (Continued)
To program a Duress code:
Enter your Master Code + 8 + 8 + [desired 4-digit duress code].
The touchpad will beep once, indicating acceptance.
Important: The Duress code must differ from the Master Code or any other User's Code!
To change the Duress code:
Enter Master Code + 8 + 8 + [new 4-digit duress code].
To delete the Duress code:
Enter your Master Code + 8 + 8, and then stop.
When the touchpad beeps once it signifies that the code has been deleted.
1. Enter your Master code and press the CODE [8] key.
2. Enter "2".
3. Enter your new Master code.
4. Enter your new Master code again. The touchpad will beep 3 times, indicating
acceptance.
Example: + 8 + 2 +
MASTER CODE
If your system supports "Quick Arming", the [#] key can be pressed in place of the security
code when arming the system. The security code is always required, however, when
disarming the system. Ask your installer if "Quick Arming" is active for your system; if so,
check here.
If your system includes a Smartphone module, your installer will have programmed a 2-digit
phone access code for your system, which you should record in the boxes on the left.
Complete information regarding the use of this phone access feature is provided in a
separate manual entitled PHONE ACCESS USER'S GUIDE, which accompanies the
Smartphone module.
– 11 –
+
NEW MASTER CODE NEW MASTER CODE
again