ADT FOCUS 200 PLUS Installation And Setup Manual page 142

FOCUS 200 PLUS Installation and Setup Guide
Person With Janitor Privilege
User Action
Entry
Janitor uses the coded
key/card and unlocks the
door.
Exit
Janitor exits and presses
the pushbutton.
Janitor exits and presses
the pushbutton, closes
the door, uses the coded
key/card (or Janitor
Keyswitch).
Janitor closes the door,
but forgets to use the
coded key/card (or
Janitor Keyswitch).
Entry
Number
65 (ARM)
66 (DAR)
67 (NAR)
If an RF transmitter is used to arm or disarm the system, an operating panel addressed to 0 on
Communication Group 0 will allow access to the menu prompts whenever the button on the transmitter is
pressed. Therefore, to ensure that unauthorized personnel will not have access to the operating panel,
position it in a secure area.
If an RF transmitter is used to arm or disarm the system, the point must be linked to a user. Otherwise, the
system will show the arm/disarm prompts when the button is pressed, but the system will not change state.
13-6
BA Groups
Status
On
Normal
Normal
Not Ready
Normal
Normal
Description Function
Arming This is a special-purpose point type, reserved for 5800 Series wireless
transmitters, which turns on the BA group when the point is
activated.
Disarm This is a special-purpose point type, reserved for 5800 Series wireless
transmitters, which turns off the BA group when the point is
activated.
No Alarm This point type is used to trigger an output point (relay), but without
triggering an alarm condition (e.g., for lobby access door).
Response
Result
LED Status
On Indicates BA groups are On.
Slow flashing (1-sec Indicates Janitor points in all BA groups
On/2-sec Off). have become alarm shunted.
Changes from slow to 1-minute window starts.
fast flashing (1-sec
On/1-sec Off).
Remains slow flashing. Indicates BA groups are not normal.
Changes to On steady. Indicates alarm shunt has been removed
from each Janitor point in system and BA
groups are On.
Note: The door must be closed and locked
before using the passcode/keycode.
At end of 1-minute Indicates BA groups are On, but Janitor
window goes to a slow points in each group are still alarm
flashing condition. shunted.