Foreword - Animo OptiBean Service Book

OptiBean (XL)
5. MAINTENANCE .....................................................................................................................59
5.1 Daily rinsing program
5.2 Weekly cleaning program .................................................................................................60
5.3 Periodic maintenance ......................................................................................................61
5.3.1 Service boiler
5.3.2 Service brewer
5.4 Service contracts ..............................................................................................................62
5.4.1 Servicing
5.5 Descaling instructions .....................................................................................................66
5.6 Maintenances espresso group .........................................................................................69
5.6.1 Replacement kit 25K
5.7 Check / set pump pressure .............................................................................................71
6. TRANSPORT / SHUT DOWN ...............................................................................................72
7. COMPONENT ACCESSIBILITY ...........................................................................................73
8. ELECTRONICS OVERVIEW ................................................................................................75
8.1 Main control
8.1.1 Main circuit board inputs .......................................................................................76
8.1.2 Main circuit board outputs
8.1.3 Main circuit board communication ........................................................................78
8.2 Interface / Display ...........................................................................................................79
8.2.1 Connections
8.3 Power supply ..................................................................................................................80
8.3.1 Connections
8.4 Grinder circuit board .......................................................................................................81
8.4.1 Connections
9. DEFECT RECTIFICATION.....................................................................................................82
9.1 Read log
9.2 Erase log
9.3 Display message during use ............................................................................................83
9.4 Troubleshooting ..............................................................................................................85
10. Special options .......................................................................................................................88
10.1 Installation drain set
10.2 Installtion Hot & Cold
10.3 Installation OptiBean with waste..... ...............................................................................89
11. PAYMENT SYSTEMS ...........................................................................................................73
11.1 Coin mechanism (optional)
11.1.1 Standard con¿ guration
11.1.2 Coin blocking
11.1.3 Activate existing token .........................................................................................74
11.1.4 Programme a new token
11.1.5 Accepting euros and tokens
11.1.6 Other currencies (no euros)
11.1.7 Accepting tokens only ..........................................................................................75
11.1.8 Coin channel cleaning
11.2 Coin changer (optional) .................................................................................................76
11.2.1 Fault analysis
DIMENSIONS ................................................................................Last page of this document
4 2013/08 Rev. 0.5
OptiBean (XL)
© 2013 Animo®
All rights reserved.
No part of this document may be reproduced and/or made public in print, micro¿ lm, electronic media
or any other form without the manufacturer's prior consent. This also applies to the corresponding
diagrams and/or charts.

FOREWORD

Purpose of this document
This document is intended as a service appendix in addition to the user manual with which authorised
trained service personnel can install, program and maintain this machine.
- By authorised trained service personnel is meant: persons who can install, program,
maintain and carry our repairs on the machine.
Most of the settings, including the product settings are secured by a PIN code. This PIN code is
intended to prevent the user accessing the service menu.
It is recommended not to leave this document with the user after installation and to change the
standard factory PIN code.
All chapters and sections are numbered. The various ¿ gures referred to in the text can be found in the
illustrations at the front of this booklet or with the subjects concerned.
Pictograms and symbols
NOTE
General instructions for: WARNING, CAUTION or NOTE.
CAUTION !
Warning of possible damage to the machine, other equipment or the environment.
WARNING
Warning of serious damage to the machine or physical injury.
WARNING
Warning of an electrical or steam hazard.
WARNING
Warning of electrostatic discharge (ESD) to electronics.
2013/08 Rev. 0.5 5
GB