Foreword - Animo OptiBean Service Book

OptiBean
7. COMPONENT ACCESSIBILITY ...........................................................................................60
8. ELECTRONICS OVERVIEW ................................................................................................62
8.1 Main control
8.1.1 Main circuit board inputs .......................................................................................63
8.1.2 Main circuit board outputs
8.1.3 Main circuit board communication ........................................................................64
8.2 Interface / Display ...........................................................................................................66
8.2.1 Connections
8.3 Power supply ..................................................................................................................67
8.3.1 Connections
8.4 Grinder circuit board .......................................................................................................68
8.4.1 Connections
9. DEFECT RECTIFICATION.....................................................................................................69
9.1 Read log .........................................................................................................................69
9.2 Clear log .........................................................................................................................60
9.3 Fault analysis ..................................................................................................................70
10. PAYMENT SYSTEMS ...........................................................................................................73
10.1 Coin mechanism (optional)
10.1.1 Standard confi guration
10.1.2 Coin blocking
10.1.3 Activate existing token .........................................................................................74
10.1.4 Programme a new token
10.1.5 Accepting euros and tokens
10.1.6 Accepting tokens only ..........................................................................................75
10.1.7 Coin channel cleaning
10.2 Coin changer (optional) .................................................................................................76
10.2.1 Fault analysis
DIMENSIONS ................................................................................Last page of this document
4 2011/06 Rev. 0.4
OptiBean
© 2011 Animo®
All rights reserved.
No part of this document may be reproduced and/or made public in print, microfi lm, electronic media
or any other form without the manufacturer's prior consent. This also applies to the corresponding
diagrams and/or charts.

FOREWORD

Purpose of this document
This document is intended as a service appendix in addition to the user manual with which authorised
trained service personnel can install, program and maintain this machine.
- By authorised trained service personnel is meant: persons who can install, program,
maintain and carry our repairs on the machine.
Most of the settings, including the product settings are secured by a PIN code. This PIN code is
intended to prevent the user accessing the service menu.
It is recommended not to leave this document with the user after installation and to change the
standard factory PIN code.
All chapters and sections are numbered. The various fi gures referred to in the text can be found in the
illustrations at the front of this booklet or with the subjects concerned.
Pictograms and symbols
NOTE
General instructions for: WARNING, CAUTION or NOTE.
CAUTION !
Warning of possible damage to the machine, other equipment or the environment.
WARNING
Warning of serious damage to the machine or physical injury.
WARNING
Warning of an electrical or steam hazard.
WARNING
Warning of electrostatic discharge (ESD) to electronics.
2011/06 Rev. 0.4 5
GB