Evinrude E-Tec Engine Warnings - BRP I-Command Evinrude Etec Series User Manual

Evinrude E-TEC Engine Warnings

The I-Command gauges monitor engine conditions and display warnings in the event of a malfunction. The
following table lists warnings that are specific to Evinrude E-TEC models. Refer to the outboard Operator's
Guide if any engine warnings are displayed.
WARNING MESSAGE DISPLAYED
Sensor malfunction see dealer
RPM reductn activated see dealer
Winterization Mode activated
Overheat RPM reductn activated see manual
Low battery voltage see manual
Overheat Eng Shutdwn see manual
No Oil Shutdwn see manual
No Oil RPM reductn check oil
Water in Fuel, service soon
POSSIBLE CAUSE / PROCEDURE
Throttle position sensor fault detected
Analog 5V supply overload detected
Exhaust pressure circuit fault detected
System Voltage below expected range
System Voltage above expected range
Auto-winterization routine activated
EMM temperature above expected range
Battery voltage below expected range
Engine shutdown, EMM above max temperature
Engine shutdown, engine above max temperature
Engine shutdown, excessive no oil fault
Oil solenoid open circuit
Water in fuel detected
88