BRP I-Command Evinrude Etec Series User Manual page 10

Warning Horn
Connect the yellow wire from the instrument to the black wire of the warning
horn. Connect the blue wire from the instrument to the red wire of the warning
horn. Each instrument should be installed with a warning horn. Mount each
warning horn in a protected area and so horn is audible for operator.
Navigation Lights (Optional)
Connecting the light wiring for the I-Command instrument to the boat's naviga-
tion lights will provide instrument lighting if the instrument backlight setting is set
to lowest setting and the boat's navigation lights are turned ON.
If desired, connect the white wire from the instrument to the switched positive
(B+) of the boat's navigation lights and the black wire from the instrument to
ground (GND).
Single Engine Power Supply Harness:
Warning Horn
Connect the red wire of the power supply harness to the purple switched B+
accessory wire of the ignition and trim/tilt wire harness. Connect the black wire
of the power harness to the black ground wire of the ignition and trim/tilt harness.
Multiple Engine Power Supply Harness:
Connect the purple wire(s) of the power supply harness to the purple switched B+ accessory wire of the igni-
tion and trim/tilt wire harness(s). Connect the black wire of the power harness to a black ground wire of the
ignition and trim/tilt harness. (Optional: connect the red wire of the power harness to a switched B+ power
supply of the boat.)
8