Maintenance; Legal Information - Otto Bock 17F24 Series Instructions For Use Manual

Improving corrosion protection
Polish or sinter the product for improved corrosion protection. Ottobock
recommends the 618T40* sintering powder for surface coating.
► Do not heat the material longer than 5 minutes at max. 150 °C for sur­
face coating.
Using protective devices
► Use joint protectors to protect the product against soiling.
6 Cleaning
Promptly clean the product after contact with:
• Water containing salt, chlorine or soap, perspiration, urine or splashed
water (e.g. after rain) and soiling.
1) Rinse the product with clear fresh water.
2) Dry the product with a cloth or allow it to air dry. Avoid exposure to direct
heat (e.g. from an oven or radiator).

7 Maintenance

INFORMATION
The product may be exposed to increased loads by the patient.
► Shorten the maintenance intervals according to the expected loads.
The manufacturer requires at least a semi-annual inspection of the product
to verify functionality and check for wear.
Only use 633F7 special lubricant.
Replacing the bearing nut
1) Loosen the joint screw and remove the bearing nut.
2) Ream the bore hole in the joint bar and the foot stirrup to the size of the
new bearing nut.
3) Assemble the orthotic joint with the joint screw and the new bearing nut.
4) Clean the threads of the screw connections using a degreasing cleaner
and secure them with Loctite 241.
8 Disposal
Dispose of the product in accordance with national regulations.

9 Legal information

All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
16