Commissioning; Preparation; Table 7: Example Of A Fieldbus Node Setup - WAGO 753-647 Manual

WAGO-I/O-SYSTEM 750
753-647 DALI Multi-Master Module
Pos: 72 /Alle Serien (Allgemeine Module)/Überschriften für alle Serien/Inbetriebnehmen - Konfigurieren - Parametrieren/In Betrieb nehmen - Überschrift 1 @ 4\mod_1240901452750_21.doc @ 31570 @ 1 @ 1
7

Commissioning

Pos: 73 /Serie 753 (WAGO-I/O-SYSTEM)/In Betrieb nehmen/DALI-Multi-Master-Klemme in Betrieb nehmen (753-0647) @ 12\mod_1331285793629_21.doc @ 90560 @ 22222 @ 1
7.1

Preparation

A prerequisite for the commissioning example described below is that you have
correctly installed and set up the hardware for your fieldbus node and the DALI
network and that these items all function properly.
Either the 753-620 DC/DC converter or the 787-1007 external power supply unit
can be used for power supply for the DALI-Multi-Master module at the fieldbus
node. Connection of the power supply is made as explained in the installation
instructions (see Section "Installation Notes").
In the example given here, the fieldbus node consists of the following
WAGO-I/O-SYSTEM components:
Table 19: Example of a fieldbus node setup
Item number
750-881
753-620
753-647
750-600
The DALI bus has been connected to the +/- DALI terminals of the DALI-Multi-
Master module and has at least one DALI ECG as a bus slave.
The PC is linked to the fieldbus node via an RJ-45 network cable.
The PC's network card must be set based on the address range for the fieldbus
node.
As an alternative, connection can also be made via the fieldbus controller serial
interface. Use the WAGO communication cable to set up a physical connection
via the serial service port. This cable is supplied with the WAGO-I/O-PRO (Item
No.: 759-333) programming software, or can be obtained as an accessory under
Item No.: 750-920.
You can open the WAGO-DALI Configurator directly via the WAGO-I/O-
CHECK software to start up the DALI-Multi-Master module and then configure
the DALI network linked to the module.
Get WAGO-I/O-CHECK!
You can obtain the WAGO-I/O-CHECK software on a CD under Item No. 759-
302. This CD contains all the application program files.
Manual
Version 1.0.0
Designation
Programmable Fieldbus Controller ETHERNET (PLC)
DC/DC converter
DALI Multi-Master Module
End module
Commissioning 49