Installing Memory In The 8348-21C; Placement Rules For Memory In The 8348-21C System - IBM Power Systems S812LC 8348-21C Installation Manual

Figure 18. Locking the rear drive tray handle
7. Start the system. For instructions, see "Starting the 8348-21C system" on page 63.
8. Configure the installed or replaced drive for your environment.
a. After you insert a new drive, you must rescan for the device.
v Ubuntu: To run the rescan command in Ubuntu, log into the system as the root user, and run
the command:
rescan-scsi-bus
This tool is provided in the scsitools package, which can be installed by using the command:
sudo apt-get install scsitools
v REHL 7.2: To run the rescan command in Red Hat Linux, log into the system as the root user,
and run the command:
rescan-scsi-bus -a
This tool is provided in the sg3_utils package, which can be installed by using the command:
yum install sg3_utils
b. Load or restore data from your backup media. If a drive failed, refer to Recovering from a Disk
Drive Failure (www.adaptec.com/en-us/support/infocenter/release-2015-1/index.jsp?topic=/
RAID_IUG.xml/Topics/Recovering_from_a_Disk_Drive_Failure.html).

Installing memory in the 8348-21C

Learn how to install memory in the IBM Power System S812LC (8348-21C) system.

Placement rules for memory in the 8348-21C system

Learn about the configurations and rules that apply to adding memory to the IBM Power System S812LC
(8348-21C) system.
Installing and configuring the system
19