Table of Contents
Advertisement
To install a 2.5–inch simple-swap hard disk drive or solid-state drive, complete the
following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all attached devices (see "Turning off the system-board
3. Remove the filler panel from the simple-swap hard disk drive bay.
4. Touch the static-protective package that contains the hard disk drive or
5. Align the drive with the guide rails in the drive bay.
6. Slide the retention tab; then, carefully slide the drive into the bay until it stops,
7. Install the filler panel in the simple-swap hard disk drive bay.
If you have other devices to install or remove, do so now. Otherwise, turn on the
system-board tray (see "Turning on the system-board tray" on page 21).
Note: If the server has a PCIe RAID adapter and you install or remove a hard disk
drive, see the documentation that comes with your RAID adapter for information
about reconfiguring the disk arrays.
Installing a memory module
The following notes describe the types of dual inline memory modules (DIMMs) that
the system-board tray supports and other information that you must consider when
you install DIMMs:
v The system-board tray supports only industry-standard double-data-rate 3
v The system-board tray supports up to 16 DIMMs.
v The system-board tray supports three single-rank or dual-rank DIMMs per
v Table 2 lists the DIMM connectors on each memory channel.
40
System x iDataPlex dx360 M2: User's Guide
on page 23.
tray" on page 21).
solid-state drive to any unpainted metal surface on the chassis or rack; then,
remove the drive from the package.
Attention:
Do not press on the top of the drive. Pressing the top might
damage the drive.
and release the retention tab.
(DDR3), -800, -1066, or -1333 MHz, PC3-10600R-999, registered, synchronous
dynamic random-access memory (SDRAM) dual inline memory modules (DIMMs)
with error correcting code (ECC).
channel. Table 1 shows an example of the maximum amount of memory that you
can install.
Table 1. Maximum memory installation
Maximum number
DIMM type
of DIMMs
Single-rank
16
Dual-rank
16
Dual-rank
16
Table 2. Connectors on each memory channel
Memory channel
Channel 0
DIMM size
1 GB
2 GB
4 GB
Microprocessor 1 DIMM
connectors
1, 2, and 3
Total memory
16 GB
32 GB
64 GB
Microprocessor 2 DIMM
connectors
9, 10, and 11
Advertisement
Table of Contents
