Table of Contents
Advertisement
Figure 1. Removing the filler panels
4. Determine to place the system in the rack. Record the EIA location.
5. Facing the front of the rack and working from the right side, use tape, a marker, or pencil to mark
the lower hole of each EIA unit.
6. Repeat step 5 for the corresponding holes located on the left side of the rack.
7. Go to the rear of the rack.
8. On the right side, find the EIA unit that corresponds to the bottom EIA unit marked on the front of
the rack.
9. Mark the bottom EIA unit.
10. Mark the corresponding holes on the left side of the rack.
Installing the 8348-21C system by using slide rails
If you ordered the system with the slide rail option, read this section to install the system into the rack by
using slide rails.
4
Installing the System and Ordered Parts for the 8348-21C
Advertisement
Table of Contents
