Table of Contents
Advertisement
Figure 26. Disk drive signal cable routing
e. Go to step 10 on page 32.
5. If you are installing a (FC EC3S) PCIe Gen3 SAS/SATA RAID adapter, complete this step. Otherwise
skip this step and go to step 6 on page 31.
Note: The supercapacitor module card is shipped together with the (FC EC3S) PCIe Gen3
SAS/SATA RAID adapter as a single FRU and therefore must also be installed when the SAS RAID
adapter is installed.
a. Insert the supercapacitor module card into the system backplane PCIe adapter slot, aligning it
properly and inserting it fully into the slot.
b. Insert the retaining screw and tighten it to secure the supercapacitor module card in the system,
as shown in Figure 27 on page 29.
28
Installing the System and Ordered Parts for the 8348-21C
Advertisement
Table of Contents
