Table of Contents
Advertisement
Figure 52. Replacing a power supply in the system
2. Connect and fasten the power cord to the power supply.
a. Connect the power cord to the power supply, as shown in Figure 52.
b. Use the hook-and-loop fastener and tie the power cord to the power supply handle.
Attention: This system is equipped with two power supplies. Before you continue with this
procedure, connect all power cords to the power supplies and strap them.
c. Loop the power cables. For instructions, see "Connecting the power cords to an 8348-21C system"
on page 64.
What to do next
See "Preparing the system for operation after removing and replacing internal parts for the 8348-21C" on
page 61.
Removing a front drive in the 8348-21C
Learn how to remove a front drive in the IBM Power System S812LC (8348-21C) system. The front disks
can be removed and replaced when the system is running and the system power is on.
75
Additional procedures
Advertisement
Table of Contents
Need help?
Do you have a question about the Power Systems S812LC 8348-21C and is the answer not in the manual?