Figure 9. Removing a front drive tray
3. Support the bottom of the drive tray as you slide it out of the system. Do not hold the drive tray by
the handle.
4. If you are installing more than one drive, remove additional drive trays.
5. Install a drive into the tray. Orient the drive such that the connectors are pointing to the rear of the
drive.
v A 3.5 inch drive fills the tray, as shown in Figure 10 on page 13. Fasten the drive to the sides of the
tray with four screws (2 on each side).
12
Installing the System and Ordered Parts for the 8348-21C