Table of Contents
Advertisement
Installing memory modules
Complete the following steps to install a DIMM:
Attention: When you handle electrostatic discharge-sensitive devices (ESD), take
precautions to avoid damage from static electricity. For details on handling these
devices, refer to "Handling electrostatic discharge-sensitive devices" on page 152.
1.
Review the information in "Before you begin" on page 46 and the documentation
that comes with your option.
2.
Turn off the server/workstation and peripheral devices and disconnect the power
cord and all external cables; then, remove the cover (see "Removing the cover" on
page 49 for details).
3.
If necessary, remove the PCI card in slot 2 for easier access to the DIMM
connectors.
4.
Touch the static-protective package containing the DIMM to any unpainted metal
surface on the server/workstation. Then, remove the DIMM from the package.
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, handle the clips gently.
5.
Install the DIMM in the connector.
Attention: To prevent damage to the DIMM connectors do not force the memory
module into the connector.
a.
Turn the DIMM so that the index slots align correctly with the connector.
Note: The DIMM has two index slots, one in the center and the other on the
b. Insert the DIMM into the connector by pressing on both corners of the DIMM
at the same time. Be sure to press straight into the connector.
Connector 1
Connector 2
Connector 3
Connector 4
left half of the DIMMS connector edge.
85
Installing options
Advertisement
Table of Contents
