Table of Contents
Advertisement
Table 11. POST conditions and results (continued)
Green LED
Yellow LED
Slow flash
Flashing
Fast flash
Off
Fast flash
On
Fast flash
Slow flash
Fast flash
Fast flash
Fast flash
Flashing
Replacing Fibre Channel adapters by using hot swap
When hot swapping Fibre Channel adapters, be aware that device-related software for the storage devices
might have extra devices (for example, the disk array router (dar) device that is associated with the fiber
array storage technology (FAStT) or DS4800) that need to be removed. See the specific storage device
documentation for information about how to remove these additional devices.
The new adapter has a unique worldwide port name (WWPN). Check the zoning and logical unit
number (LUN) assignments to ensure that the new adapter functions as expected.
PCIe2 LP 2-port 10 GbE BaseT RJ45 Adapter (FC EL3Z; CCIN 2CC4)
Learn about the specifications and operating system requirements for the feature code (FC) EL3Z adapter.
Overview
The PCIe2 LP 2-port 10 GbE BaseT RJ45 Adapter is a PCI Express (PCIe) generation 2, x8, short
form-factor, low-profile adapter. The adapter provides two 10 Gb RJ45 ports. This adapter provides a
PCIe 2.0 host bus interface. The adapter supports the Ethernet network interface controller (NIC)
function. The adapter is a high-performance adapter that consolidates traffic for networking. The link
aggregation and failover features of the adapter make it suitable for critical network applications that
require redundancy and high availability. Figure 38 on page 49 shows the FC EL3Z adapter.
The ports default to auto negotiate the highest speed either at 10 Gb (10G BaseT), 1Gb (1000 BaseT), or
100 Mb (100 BaseT) full duplex. Each RJ45 port can be configured independent of the other port. Each
RJ45 port is connected with a 4-pair, CAT-6A cable, and is supported for distances of up to 100 meters.
The adapter provides the following features:
v The adapter is a PCIe2 NIC network convergence adapter.
v The 10 Gb RJ45 ports can function in the NIC mode.
v The adapter can be used as the host local area network (LAN) adapter.
v The adapter supports interrupt moderation to deliver increased performance while significantly
reducing processor utilization
v The adapter supports dual port operation in any PCIe3 or PCIe2 slot.
v The adapter supports auto-negotiation, full-duplex only.
v The adapter supports multiple media-access control (MAC) per interface.
v The adapter supports integrated media-access control (MAC) and physical layer (PHY).
v The adapter supports the following standards for the different ports and functions:
– IEEE 802.3ae in the 10 GbE ports
48
Installing the System and Ordered Parts for the 8348-21C
State
Restricted offline mode, test
active
Debug monitor in restricted
mode
Not defined
Debug monitor in test fixture
mode
Debug monitor in remote
debug mode
Not defined
Action to be taken
None
None
None
None
None
None
Advertisement
Table of Contents
