Introduction; Symbols Used In This Manual; Approvals; Copyright - Danfoss VLT OneGearDrive Operating Instructions Manual

Introduction

1 1
1 Introduction

1.1 Symbols used in this Manual

The following symbols are used in this manual.
WARNING
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury. It may
also be used to alert against unsafe practices.
CAUTION
Indicates a situation that may result in equipment or
property-damage-only accidents.
NOTE
Indicates highlighted information that should be regarded
with attention to avoid mistakes or operating equipment
at less than optimal performance.

1.2 Approvals

Table 1.1 Approvals

1.3 Copyright

Disclosure, duplication and sale of this document, as well
as communication of its content, are prohibited unless
explicitly permitted. Infringement of this prohibition incurs
liability for damages. All rights reserved with regard to
patents, utility patents, and registered designs.
OneGearDrive is a registered trademark.
4
®
VLT OneGearDrive Operating Instructions

1.4 Disclaimer

No liability is assumed for any damage or breakdown
resulting from:
•
•
•
•

1.5 Service and Support

Contact your local service representative for service and
support:
www.danfoss.com/Contact/Worldwide/

1.6 Purpose of these Operating Instructions

The purpose of these Operating Instructions is to describe
the VLT
contain information about:
•
•
•
•
•
•
NOTE
For reasons of clarity, the Operating Instructions and safety
information do not contain all information relating to all
geared motors types and cannot take into account every
conceivable case of installation, operation, or maintenance.
The information is limited to that which is required for
qualified personnel in normal working situations. Any
unclear points can be clarified by contacting Danfoss.
These Operating Instructions are intended for use by
qualified personnel. Read these Operating Instructions in
full in order to use the VLT
professionally. Pay particular attention to the safety
instructions and general warnings.
®
MG75C302 - VLT is a registered Danfoss trademark
Failure to observe the information in the
instruction manuals
Unauthorised modifications to the VLT
OneGearDrive
Operator error
Improper work on or with the VLT
OneGearDrive.
®
OneGearDrive. These Operating Instructions
Safety
Installation
Commissioning
Maintenance and Repair
Specifications
Options and Accessories
®
OneGearDrive safely and
®
®