Due Diligence; Intended Use; Forseeable Misuse - Danfoss VLT OneGearDrive Operating Instructions Manual

Introduction
1 1

1.9 Due Diligence

The operator and/or fabricator must ensure that:
•
The units are used only as intended
•
The units are operated only in a perfect
operational condition.The Operating Instructions
are always available near the unit in complete
and readable form
•
The unit is fitted, installed, commissioned, and
maintained only by adequately qualified and
authorised personnel
•
These personnel are regularly instructed on all
relevant matters of occupational safety and
environmental protection, as well as the contents
of the Operating Instructions and in particular the
instructions it contains
•
The product markings and identification markings
applied to the unit, as well as safety and warning
instructions, are not removed and are always kept
in a legible condition
•
The national and international regulations
regarding the control of machinery and
equipment, that are applicable at the place of
use, are complied with
•
The users always have all current information
relevant to their interests about the unit and its
use and operation

1.10 Intended Use

These machines are intended for commercial installations,
unless otherwise expressly agreed. They comply with the
standards of the series EN 60034/DIN VDE 0530. Use in a
potentially explosive atmosphere is forbidden, if not
expressly intended for this purpose. If in a special case -
use in non-commercial installations - increased safety
precautions are required (e.g. protection against access by
children's fingers), these conditions must be ensured when
setting up the installation. The machines are designed for
ambient temperatures between -20 ˚C to +40 ˚C as well as
for installation heights up to 1000 m above sea level. Any
deviations found on the nameplate must be considered.
Ensure that the conditions at the place of work correspond
to all the nameplate data.
6
®
VLT OneGearDrive Operating Instructions
CAUTION
Low-voltage machines are components for installation in
machines in the sense of the machinery directive
2006/42/EC. It is forbidden to use the machine until
conformity of the final product with this directive is
established (refer to EN 60204-01).

1.11 Forseeable Misuse

Any use not expressly approved by Danfoss constitutes
misuse. This also applies to failure to comply with the
specified operating conditions and applications.
Danfoss assumes no liability of any sort for damage attrib-
utable to improper use.
®
MG75C302 - VLT is a registered Danfoss trademark