Changing The Oil; Spare Parts - Danfoss VLT OneGearDrive Operating Instructions Manual

Service and Maintenance

4.4.4 Changing the Oil

CAUTION
Danger of burns
The surface of the VLT
temperatures during operation.
•
4 4
Do not touch the VLT
cooled down.
CAUTION
Danger of burns
The oil in the VLT
atures during operation.
•
Do not carry out the oil change until the oil has
cooled down sufficiently.
Illustration 4.3 VLT
Draining the oil
1.
Once the VLT
remove it from your system
2.
Bring the VLT
position and remove oil screws 1 and 2
3.
Turn the VLT
position and drain the oil through screw hole 1
into a suitable container
4.
Turn the VLT
position
20
VLT
®
OneGearDrive can reach high
®
OneGearDrive until it has
®
OneGearDrive reaches high temper-
2
1
®
OneGearDrive Oil Screws 1 and 2
®
OneGearDrive has cooled down,
®
OneGearDrive into a vertical
®
OneGearDrive into a horizontal
®
OneGearDrive back into a vertical
MG75C302 - VLT
®
OneGearDrive Operating Instructions
Filling the oil
NOTE
The required oil quantities can be found on the nameplate
and in 4.4.3 Lubricant Volume.
1.
Fill the VLT
amount of oil through screw hole 1.
2. Remove all traces of oil from the surface of the
VLT
3. Re-insert and tighten oil screws 1 and 2.

4.5 Spare Parts

Spare parts can be ordered via the Danfoss VLT Shop:
vltshop.danfoss.com
®
is a registered Danfoss trademark
®
OneGearDrive with the appropriate
®
OneGearDrive using a soft cloth.