Cage Clamp Connection Diagram - Danfoss VLT OneGearDrive Operating Instructions Manual

Installation

2.10 Cage Clamp Connection Diagram

2 2
CAUTION
Refer to the Operating Instructions for VLT
terminals.
Do not connect the VLT
Illustration 2.6 shows the VLT
thermal protection.
Illustration 2.6 Cage Clamp Connection Diagram
Description
Motor winding
Protective Earth
Temperature protection
KTY 84-130
Table 2.5 Cage Clamp Connections
1) When connected to VLT
information about parameter setting and programming, refer to the corresponding operating instructions.
T1
KTY 84-130
T2
Table 2.6 Connections T1 and T2
1) Only if connected
12
®
VLT OneGearDrive Operating Instructions
®
AutomationDrive FC 302 and VLT
®
OneGearDrive directly to the power supply.
®
OneGearDrive DA09LA10 with terminal box in Y-connection and the connection to the
V1
Inverter output
U
V
W
PE
1) T1
T2
®
AutomationDrive FC 302 and VLT
®
VLT AutomationDrive FC 302
MG75C302 - VLT
®
Decentral Drive FCD 302 to connect the
W1
U1
U V W PE T1
U V W
Colour Typical cross section
black
AWG 16/1.5 mm
blue
brown
yellow/green
AWG 16/1.5 mm
white
AWG 20/0.75 mm
brown
®
Decentral Drive FCD 302, use analog input terminal 54, KTY sensor 1. For
1)
VLT
KTY Sensor 1
Analog Input 54
®
is a registered Danfoss trademark
T2
Maximum cross section
2 2
AWG 14/2.5 mm
2 AWG 14/2.5 mm 2
2 AWG 16/1.5 mm 2
®
1)
Decentral Drive FCD 302