Safety Information For The Operation Of Geared Motors; General; Transportation, Storage; Inspection On Receipt - Danfoss VLT OneGearDrive Operating Instructions Manual

Introduction
These Operating Instructions are an integral part of the
®
VLT OneGearDrive and also contain important service
information. Therefore keep these operating instructions
®
available with the VLT OneGearDrive at all times.
Compliance with the information in the Operating
Instructions is a prerequisite for:
•
Trouble-free operation
•
Recognition of product liability claims
Therefore, read these Operating Instructions before
®
working with the VLT OneGearDrive.
1.7 Safety Information for the Operation of
Geared Motors

1.7.1 General

This safety information applies in addition to the relevant
product-specific Operating Instructions and for safety
reasons must be taken into particular consideration in
every case. This safety information is intended to protect
persons and objects from injury and hazards which can
arise from improper use, incorrect operation, inadequate
maintenance, or other incorrect handling of electric drive
units in industrial installations. Low-voltage machines have
rotating parts and may have parts that are live, even when
the machine is at rest, and surfaces that may become hot
in operation. Warning signs and information signs on the
machine must be observed without exception. Details can
be found in our detailed Operating Instructions. They are
provided with the machine when it is supplied and can be
requested separately as required by stating the motor
model.

1.7.2 Transportation, Storage

1.7.2.1 Inspection on Receipt

After receiving the delivery, immediately check whether
the scope of delivery matches the shipping documents.
Danfoss will not honour claims for faults registered later.
Register a complaint immediately:
•
with the carrier in case of visible transport
damage
•
with the responsible Danfoss representative in
case of visible defects or incomplete delivery
Commissioning may have to be suspended if the unit is
damaged.
®
VLT OneGearDrive Operating Instructions

1.7.2.2 Transport

Before transporting the VLT
provided must be firmly tightened down to its bearing
surface. The eye bolt can only be used to transport the
VLT
machines.
If the VLT
dust free environment with a low vibration rating of v
0,2 mm/s.
Damage sustained during storage:

1.8 Qualified Personnel

All necessary work on electric drive units, in particular also
planning work, transport, assembly, installation, commis-
sioning, maintenance, repair, may only be performed by
adequately qualified personnel (e.g. electrical engineers as
specified in draft EN 50 110-1/DIN VDE 0105), who have
the Operating Instructions provided and other product
documentation available during any corresponding work
and who are obliged to abide by the instructions
contained therein. This work must be monitored by a
specialist supervisor. Qualified personnel are persons who
are authorised due to training, experience, and instruction
as well as their knowledge of relevant standards, rules,
accident prevention regulations, and operating conditions.
The person responsible for the safety of the installation
must perform the activities required in each case and be
able to recognise and avoid potential hazards.
Knowledge of first-aid measures and of the available
lifesaving equipment is also required.
Non-qualified personnel are forbidden to work on the VLT
OneGearDrive.
®
MG75C302 - VLT is a registered Danfoss trademark
®
OneGearDrive the eye bolt
®
OneGearDrive unit and not for lifting attached
®
OneGearDrive is to be stored, ensure a dry,
•
The life of the lubricants and seals is reduced
with longer storage times.
•
There is a risk of fracture at very low temper-
atures (under approximately -20 ˚C)
•
If the transport eye bolts are replaced, use drop
forged eye bolts as specified in DIN 580.
1 1
<
eff
®
5