Connections - Danfoss VLT OneGearDrive Operating Instructions Manual

Specifications

6.7.2.4 Connections

Illustration 6.16 shows the cage clamp and the connection to AutomationDrive FC 302.
V1
6 6
Illustration 6.16 Cage Clamp and Connection to AutomationDrive FC 302.
Description
Brake power
supply
Table 6.5 Mechanical Brake Option Connections
NOTE
Connect terminal 05 on the VLT
The connection and use of the mechanical brake has been tested and released with VLT
Decentral Drive FCD 302. Any other inverter may require a different connection. Contact Danfoss Service for further
information.
For information about parameter setting and programming when using VLT
Drive FCD 302, refer to the corresponding Operating Instructions.
30
W1
U1
U V W PE T1
U V W
Coding Pin Colour Typical cross
section
B1 1 Brown AWG 20/
2
0.75 mm
B2 2 Black
®
AutomationDrive FC 302 to the 400 V AC power supply.
MG75C302 - VLT
®
VLT OneGearDrive Operating Instructions
~ ~
T2 B1 B2
1 2
®
Maximum cross
VLT AutomationDrive FC 302
section
AWG 14/ 400 V AC power supply
2
2.5 mm
Terminal 04
®
is a registered Danfoss trademark
®
VLT
Decentral Drive
FCD 302
Terminal 122
(MBR+)
Terminal 123
(MBR–)
®
AutomationDrive FC 302 and VLT
®
AutomationDrive FC 302 or VLT
External
DC power
supply
+
–
®
®
Decentral