Avaya Equinox Manual page 44

Installing the new streaming and recording server
No. Task
provided
equipment).
4 Verify that the
rack is installed
according to the
manufacturer's
instructions and
in accordance
with all local
codes and laws.
5 Verify that the
rack is grounded
in accordance
with local
electrical code.
6 Determine and
plan the vertical
spacing of the
servers in the
frame.
7 Attach the rails to
the rack.
8 Attach the server
to the rack.
9 Connect the
peripheral
devices to the
server.
August 2017
Reference Avaya recommendation
User Guide: To install the server into a rack with square, round, or
Installing the threaded holes, refer to the instructions that ship with the
server into the rack hardware kit.
rack
User Guide: The server must be grounded for proper operation and
Electrical safety.
grounding
requirements
User Guide: Servers draw in cool air through the front and expel warm air
Space and through the rear. Therefore, the front rack doors must be
Airflow adequately ventilated to allow ambient room air to enter the
Requirements cabinet, and the rear door must be adequately ventilated to
allow the warm air to escape from the cabinet.
User Guide: To install the server into a rack with square, round, or
Installing the threaded holes, refer to the instructions that ship with the
server into the rack hardware kit. If these rails do not fit the rack the
rack customer must provide rails or a shelf for rack installation.
Also the rails included with the server might not work with
round hole racks, in which case the customer can obtain rails
and/or a shelf from a distributor. (RackSolutions.com)
User Guide:
Warning:
Installing the
This server is very heavy. To reduce the risk of personal
server into the
injury or damage to the equipment:
rack
• Get help lifting and stabilizing the product during
• Use caution when installing the server in or removing
User Guide: Network connections, power cords
Setup
See Avaya application installation documentation.
• Connecting
peripheral
Installing the Avaya Equinox Streaming and Recording Server
Comments on this document? infodev@avaya.com
installation or removal, especially when the product is
not fastened to the rails. HP recommends that a
minimum of two people are required for all rack server
installations. A third person may be required to help
align the server if the server is installed higher than
chest level.
the server from the rack; it is unstable when not
fastened to the rails.
Table continues...
44