Avaya Equinox Manual page 30

Installing the new streaming and recording server
Front view of Dell
No. Item
1 Power-On Indicator,
Power Button
2 NMI Button
3 System
Identification Button
4 USB Connectors (2)
5 Optical Drive
August 2017
™ ™
PowerEdge R630 Server
Icon Description
The power-on indicator lights when the system power is on. The power
button controls the power supply output to the system.
Note:
On ACPI-compliant operating systems, turning off the system using
the power button causes the system to perform a graceful shutdown
before power to the system is turned off.
Used to troubleshoot software and device driver errors when running
certain operating systems. This button can be pressed using the end of a
paper clip.
Use this button only if directed to do so by qualified support personnel or
by the operating system documentation.
The identification buttons on the front and back panels can be used to
locate a particular system within a rack. When one of these buttons is
pressed, the LCD panel on the front and the system status indicator on
the back flashes blue until one of the buttons are pressed again.
Press to toggle the system ID on and off. If the system stops responding
during POST, press and hold the system ID button for more than five
seconds to enter BIOS progress mode.
To reset the iDRAC (if not disabled in F2 iDRAC setup) press and hold
the button for more than 15 seconds.
Allows you to insert USB devices to the system. The ports are USB 2.0-
compliant.
One DVD+/-RW drive.
Note:
DVD devices are data only.
Installing the Avaya Equinox Streaming and Recording Server
Comments on this document? infodev@avaya.com
Table continues...
30