Avaya Equinox Manual page 42

Installing the new streaming and recording server
Temperature and humidity requirements
The following table lists the temperature and humidity requirements for the server.
Specification
Temperature range
Operating
Non-operating
Relative humidity (non-condensing)
Operating
Non-operating
Related links
Physically connecting the new server
Power requirements
The following table lists the power requirements for the server.
Table 7: HP 800 W CS power supply (92% efficiency)
Specification
BTU
Voltage
Plug Type
Circuit Breaker
Pole
AMP Draw
Total Watts
Note:
These numbers are based on the following typical Avaya configuration:
• qty=2 – E5-2620v3 six core processors
• qty=8x4 GB – Memory (1Rx4 PC4-2133P –R Kit)
• qty=3 – 2.5" SFF SAS HDDs
August 2017
Value
Note:
All temperature ratings shown are for sea level. An altitude derating of
1°C per 304.8 m (1.8° per 1,000 ft.) above sea level to a maximum of
3048 m (10,000 ft), no direct sustained sunlight.
10° to 35°C (50° to 95°F) Maximum rate of change is 20°C/hr (36°F/hr).
The upper limit might be limited by the type and number of options installed.
System performance may be reduced if operating with a fan fault or above
30°C (86°F).
-30° to 60°C (-22° to 140°F). Maximum rate of change is 20°C/hr (36°F/hr).
8 to 90% relative humidity (Rh), 24°C (75.2°F) maximum wet bulb
temperature, non-condensing.
5 to 95% relative humidity (Rh), 38.7°C (101.7°F) maximum wet bulb
temperature, non-condensing.
on page 26
Installing the Avaya Equinox Streaming and Recording Server
Comments on this document? infodev@avaya.com
Value
917 BTU/hr
100V — 240V
NEMA — 15
15 Amp
1
2.7 @ 100VAC
269 W
42