Step Adjustment - MUTOH ValueJet VJ-1604W Operation Instructions Manual

5.4 STEP ADJUSTMENT

After every printed swath, the media is fed a certain distance. Depending on the kind of media (weight,
backing) another media feed compensation has to be set. This to avoid the following phenomenon:

Printed swaths overlap.

White lines between every swath.
In such cases, follow the procedure below and adjust the media feed compensation value.
Display the Media feed compensation menu on the operation panel.
Step 1 :
Press the [Menu] key.
Step 2 :

Shift to the Setup menu display.

The operation panel displays "Menu 1: Setup>".
Press the [>] key.
Step 3 :

The operation panel displays "Set1: MediaType".
Press the [Enter] key.
Step 4 :

The operation panel displays "Media: Type 1".
Press the [+] key or [–] key to select the media type you wish to use.
Step 5 :
Press the [Enter] key.
Step 6 :

The operation panel displays "**>1: Print Mode".
Notes

The selected media (Type 1-30) is displayed in "**". Please refer to "Media Type menu"

Press the [+] key or [–] key to select "**>2: PF Adjust>".

Press the [>] key.
The operation panel displays "PF1: Initial Print".
o
Operation Instructions ValueJet 1604W
Chapter 5 : Preparations before printing
65 AP-77300 – Rev 1.1 -17/09/2009,