MUTOH ValueJet VJ-1604W Operation Instructions Manual page 67

Step 10 : Perform the Confirm Print.
 Press the [+] key or [–] key to select "PF3: Confirm Print".
 Press the [Enter] key.
The operation panel displays "Feed Length: 250 mm".
Notes

The length that the media is fed (feeding length) for confirmation adjustment printing is normally set at
250 mm.

If you make the feeding length longer, the accuracy of the Media feed compensation improves.
If you want to change the feeding length, press the [+] key or [–] key and change the set value.
 Press the [Enter] key.
The operation panel displays "Printing".
o
Start Confirmation adjustment printing.
o
1
 After the confirmation adjustment printing, cut the media. For more information, please refer to: "
Cutting media"
Step 11 : Measure the distance between two pluses in the confirmation adjustment print and confirm that
the distance matches the feeding length when printing.
 If the distance does not match the feeding length, perform the previous procedure again and re-
adjust.
 If the distance matches the feeding length, proceed to step 12.
N° Name
1 Feed length
2 Media feeding direction
67
Operation Instructions ValueJet 1604W
Chapter 5 : Preparations before printing
1
AP-77300 – Rev 1.1 -17/09/2009,
2