Replacing Cutting Blade - MUTOH ValueJet VJ-1604W Operation Instructions Manual

3.4 REPLACING CUTTING BLADE

This sub-section describes the replacement time and steps of razor blade.
1) Replacement time
Replace the razor blade when the following situation occurs.

If the media cannot be clearly cut.
If there is a failure in media cutting, the operation panel displays "Media Cut Error".

If fuzz, etc appears on the cut section
2) Replacing steps
Follow the procedure below to replace the razor blade.
Step 1 : If the printer is switched ON, make sure that:
Printing are other operations are not in progress.
o
The operation panel display is normal.
o
Step 2 : Display the CR Maintanence menu on the operation panel.

Press the [MENU] key.
The operation panel displays [Menu1: Setup>]
o
The operation panel shifts to the setup menu display.
o

Press the [>] key.
The operation panel displays "Set1:MediaType>"
o
Operation Instructions ValueJet 1604W
38 AP-77300 – Rev 1.1 -17/09/2009,
Chapter 3 : Installing the Unit