MUTOH ValueJet VJ-1604W Operation Instructions Manual page 32

Set the roll media to the media feed slot.
Step 4 :
Notes

Make sure that the end of the roll media is wind tightly before loading it.
Pull out the roll media about 1m from the front media feed slot.
Step 5 :
Rewind the roll media a little by rolling the flange on the roll media holder while holding the edge
Step 6 :
of the media, eliminate any slack or slant.
Notes

If you set the roll media free while rewinding, the roll media will fall out from the media feed slot on the
rear of the product.

Confirm that the right edge of the roll media does not go beyond the loading mark. If it does, it may
affect print quality.
Lower the media loading lever
Step 7 :
Notes

When loading the new roll media, cut the front edge of the media if it is not straight. Please refer to
"Cutting media".

Lower the media loading lever even further if the media does not feed well.
Close the front cover.
Step 8 :
 The operation panel displays the Media type setup menu.
N° Name
1 Roll media
2 Media feed slot
N° Name
1 Media loading lever
32
Operation Instructions ValueJet 1604W
Chapter 3 : Installing the Unit
AP-77300 – Rev 1.1 -17/09/2009,
2
1