Making A Call - NTT docomo Foma D900i Manual

Making a Call

1 Enter a phone number.
2
Press .
■
When you want to stop making a call
Press .
■
When you hear a busy signal
The line is busy. End the call by pressing
a previously-dialed number using Redial Data (see p.50).
■
If you hear an announcement indicating that the call cannot be connected
The receiver's FOMA terminal, mobile phone, or PHS terminal is off or in a place where the
signal does not reach.
■ When you hear an announcement asking you to display Caller ID and dial again
The receiver uses Caller ID Display Request Service (see p.219).
Turn Caller ID Notification on or add "186 (
dial again (see p.217, 52).
3
To end the call, press
Call time is displayed for about 5 seconds and the Standby screen reappears.
• To quickly return to the Standby screen, press
48
• About phone numbers
Calling a general
subscriber phone
Calling a mobile phone
Calling a PHS terminal
• Up to 80 digits are valid for the phone number. If more than 80 digits are
entered, they are discarded from the beginning of digits.
• If you enter a wrong number:
To delete one digit at a time, press
To delete all digits at once, press
(the Standby screen reappears).
A call is made to the displayed phone number. First the dial tone and then the
ring back tone is heard in the earpiece.
• If the receiver's phone number is saved in Phonebook, the name appears.
The number dissappears once then reappears and start blinking
.
Enter the area code even when you are in
the same area code.
090-XXXX-XXXX or 080-XXXX-XXXX
070-XXXX-XXXX
.
(戻る) or press and hold down
, wait a while and dial again. You can easily dial
31#)" before the receiver's phone number and
(OK).