Calling; Making A Call/Video Call - NTT docomo F-05J arrows Be Instruction Manual

Calling

Making a call/video call

1
From the Home screen,
2
[Dial]→Enter a phone number
･
To correct phone number, tap
Notifying caller ID :
[Not notify]
･
Your caller ID is important personal information. So,
take care when notifying people of it.
→[Select prefix]→Select a prefix
Selecting prefix :
･
Select a number registered in "Prefix settings" (prefix)
(→P74) beforehand to add before a phone number.
Adding 2-sec pause/wait :
wait]→Enter an additional number
･
Used to enter main phone number and additional code
at once when entering the code additionally during a
call for bank balance inquiries, ticket reservation
services, etc.
2-sec pause "," : When the phone number is dialed, 2-
second pause will be automatically inserted and then
additional code will be sent.
Wait ";" : When the phone number is dialed, the phone
will wait automatically and a confirmation message for
sending additional code appears. When you tap [YES],
the additional code is sent.
.
→[Caller ID notification]→[Notify]/
→[Add 2-sec pause]/[Add
3
Making a video call :
4
When a call is ended, [END CALL]
✔INFORMATION
･
With VoLTE, you can make high-quality voice and video calls.
To use VoLTE, both parties must meet the following
requirements.
- Both terminals support VoLTE
- Both parties are in a VoLTE service area
- "Network Mode" in "Cellular networks" (→P174) is set to
[4G/3G/GSM(Auto)], and "Call mode setting" is set to ON
･
On a video call, both speakers can see each other while
talking. You can also switch between voice and video calls.
- When you make a video call, voice call and packet
communication charges will apply. When you receive a
video call, packet communication charges will apply.
- Video call imaging is based on best-effort communication
(which optimizes transmission speed depending on how
busy your network is), so the quality of video images varies
depending on your network environment.
- If your terminal failed to switch to a video call during a voice
call, a massage appears on the screen indicating that the
failure occurred, and the voice call is maintained.
- Since imaging for video call varies by terminal model, your
terminal and the other party's terminal may show different
image in scope.
･
If your face etc. comes close to the proximity sensor during a
call, the display goes out. It is redisplayed by moving away
from the sensor.
67
→[Video call]
Calling