Connect - Danaher Motion 601...620 Product Manual

Setup
9.3.2

Connect

l
l
l
If a fault code (
in the display, you will find the description on page 88ff. If there is fault, fix the
problem.
Frequent causes:
Click OK to remove the error message. Detect and remove the error source. Restart the software.
76
Connect the interface cable to a serial interface on your PC and to the serial interface X6 of the
servo amplifier. USB to serial converter can be used optionally.
Switch on the 24 V power supply for the servo amplifier.
Wait about 30 seconds, until the front display of the servo amplifier displays the current classe
(e.g. for 3 amps). If the power supply voltage is switched on, too, a leading P is display-
ed (e.g. for Power, 3 amps).
) or a warning (
Double-Click the DRIVE.EXE icon on your Windows desktop to start the software.
- wrong interface chosen
- wrong connector chosen at the servo amplifier
- interface is used by another software
- 24 V auxiliary voltage for the servo amplifier not working
- interface cable broken or wrong wiring
07/2007
) or a status message (./_ / E/S) appears
You can work offline or online with .
Work ONLINE now. Select the interface where the servo am-
plifier is connected to.
The software tries to communicate with the
drive and to upload the parameters. If it's
not successful, you receive this error mes-
sage.
®
SERVOSTAR
Danaher Motion
601...620 Product Manual